Can I install my FlexiSTARTER ValueCut Edition Cloud and FlexiSIGN & PRINT Mutoh Edition on the same computer?

Yes you can. it is not a problem to install both SW editions next to each other.

With every Valuecut plotter, standard a FlexiSTARTER ValueCut Cloud SW bundle from SAi will be included

Depending on your SW selection, a second SAi SW bundle for a ValueJet printer might have been choosen (Example: FlexiSIGN & PRINT Mutoh Edition)

As you can see in below screenshot, both SW bundles were successfully installed on the same computer. 

Extra information:

• Basically, one can run a print and cut task by means of the FlexiPRINT SE Mutoh Edition bundle usage.
  Why? Since one can install a printer and cutter with this license, a print and cut task can be completed.
  
  

• The FlexiSTARTER ValueCut Cloud Edition only allows you to cut. To perform print and cut exercises too, one need to export your prepared P&C design (PDF with included ref marks) and print it with a 3rd party RIP. 
  Afterwards one can cut out your print sample by means of the FlexiSTARTER ValueCut Cloud Edition.