How to switch XPJ-1341WR-P / XPJ-1642WR / XPJ-1682SR-DSP from DS3 to DS4

Modified on Tue, 10 Feb at 10:28 AM

TABLE OF CONTENTS

Compatible printers per 10/02/2025: XPJ-1341WR-P, XPJ-1642WR, XPJ-1682SR-DSP

Before carrying out this procedure, it is advisable to perform the annual maintenance and replace the wiper and spitting sponge.

DS4 ProFlex Sublimation Ink

Procedure

To ensure optimal performance with the new ink for production, please follow this full discharge–ink load cycle:

Print and save a nozzle check of your current setup.
Run a Longstore in Diagnostics > Adjustment.
- When prompted for cleaning, press <Cancel> and reboot the printer.
- Note: Intermediate cleaning liquid is not required.
When prompted, perform an Ink Charge using the DS4 inks. Select No when 'Wash Retry' is proposed.
If the nozzle check isn’t perfect, follow up with a Little Charge.
Let the printer rest for 15 minutes after charging before starting any prints.

Print and save a nozzle check of your current setup.
Run a Ink Discharge in Diagnostics > Adjustment.
Restart the printer.
When prompted, perform an Ink Charge using the DS4 inks. Select No when 'Wash Retry' is proposed.
If the nozzle check isn’t perfect, follow up with a Little Charge.
Let the printer rest for 15 minutes after charging before starting any prints.

Due to the nature of the DS4 formulation:

Perform a fresh ICC profile calibration.
This is especially important for customers producing repeat/project work that requires strict colour consistency.

Maintaining constant temperature, pressure, and time during the calendar/heat press process is crucial.
In dye sublimation, even minor variations can lead to visible colour differences.
Apply a minimum temperature of 195°C to ensure consistent colour output.
Always follow the weekly agitation of ink pouches as indicated on the packaging.

Changelog:

10/02/2025: split conversion procedure for XPJ-1642WR / XPJ-1682SR-DSP and XPJ-1341SR-P.